Energy
M. Maghsoudizadeh; M. Ameri; E. Jahanshahi Javaran; A. MotamedSadr; A. A. Feili Monfared
Abstract
In recent years, the use of renewable energy sources and investigation on renewable energy have significantly grown. In this research, parabolic trough and linear Fresnel collectors, which are widely used in the field of solar energy, have been investigated from the point of view of exergy. First, the ...
Read More
In recent years, the use of renewable energy sources and investigation on renewable energy have significantly grown. In this research, parabolic trough and linear Fresnel collectors, which are widely used in the field of solar energy, have been investigated from the point of view of exergy. First, the energy balance equations for different components of the collector were solved using numerical methods and the temperature distribution in each component of the collector was obtained. Then the values of exergy destruction in each component of the system were calculated. The comparison of the results obtained in the present work with the results of the previous research showed a good agreement. The results showed that the exergy efficiency in the parabolic trough collector is approximately 1.5 times that of the linear Fresnel reflector. Also, changes in exergy efficiency, exergy destruction of the whole collector, output exergy cost and CO2 emission with increasing solar radiation intensity and fluid mass flow rate for both collectors have been compared and investigated.
Chemical Engineering
M. Mahmoudi; I. Mirzaee; M. Khalilian
Abstract
The exploitation of nanofluids is the most noteworthy way to make better the rate of heat transfer in solar collectors. Moreover, recently utilizing thermoelectric generators are widely studied to direct the conversion of heat into electricity. The objective of the present study is to deal with a novel ...
Read More
The exploitation of nanofluids is the most noteworthy way to make better the rate of heat transfer in solar collectors. Moreover, recently utilizing thermoelectric generators are widely studied to direct the conversion of heat into electricity. The objective of the present study is to deal with a novel multigeneration system that includes a nanofluid-based parabolic trough collector integrated with a quadruple effect absorption refrigeration cycle (cooling), a thermoelectric generator (power), a PEM electrolyzer (hydrogen), vapor generator and domestic water heater. A parametric study is accomplished to consider the effect of significant parameters such as the volume concentration of nanoparticles, solar radiation, absorption system’s generator load, strong solution concentration, and TEG’s figure of merit on the overall system performance, hydrogen production rate, cooling load, COP and useful energy obtained by the collector. It is observed that the power generated by the system is 18.78 kW and the collector energy and exergy efficiency are 82.21% and 80.48%, respectively. Furthermore, the results showed that the highest exergy destruction rate occurs in the solar system at the rate of 4461 kW. The energy and exergy COPs of the absorption chiller are discovered to be 1.527 and 0.936, respectively. By increasing the concentration of nanoparticles and the amount of solar radiation, the amount of collector useful energy increases while the hydrogen production rate and the generated power in the TEG decreased. The cooling capacity and COPs of the absorption system increased with an increase in VHTG load and decreased with an increase in concentration of the strong solution.
Energy
A. Habibzadeh; M. Abbasalizadeh; I. Mirzaee; S. Jafarmadar; H. Shirvani
Abstract
In this study, renewable energy sources including a high-temperature solar parabolic trough collector and geothermal water integrated with a modified Kalina cycle, a combined ORC-EJR cycle, an electrolyzer, an RO desalination unit, and a domestic water heater. SiO2 and TiO2 nanoparticles dissolved in ...
Read More
In this study, renewable energy sources including a high-temperature solar parabolic trough collector and geothermal water integrated with a modified Kalina cycle, a combined ORC-EJR cycle, an electrolyzer, an RO desalination unit, and a domestic water heater. SiO2 and TiO2 nanoparticles dissolved in Therminol VP1 are applied as the working fluid of the solar collector. A comparative analysis of introduced working fluids is performed from energy, exergy as well as cost analysis point of view to evaluate their efficiencies. Solar irradiation, ambient temperature, and collector inlet temperature were the parameters investigated to discover their effects on energy and exergy efficiency, solar collector outlet temperature, hydrogen production rate, and freshwater production rate. The highest generated outlet temperature of the solar collector outlet was 693.8 K obtained by Therminol VP1/SiO2 nanofluid. The maximum energy and exergy efficiencies of the proposed system were 36.69 % and 17.76 %, respectively. Moreover, it is found that by increasing the solar collector inlet temperature, the hydrogen production rate decreases while the water production rate increases.
