Energy
H. Radaei; R. Shafaghat; S. Talesh Amiri; B. Alizadeh Kharkeshi
Abstract
Considering that the heat required for the Waste heat recovery (WHR) cycle of the engine is provided from two parts of the exhaust gas and the cooling system, the mutual influence of the WHR cycle on the engine performance is undeniable. Therefore, in this numerical study, an attempt has been made to ...
Read More
Considering that the heat required for the Waste heat recovery (WHR) cycle of the engine is provided from two parts of the exhaust gas and the cooling system, the mutual influence of the WHR cycle on the engine performance is undeniable. Therefore, in this numerical study, an attempt has been made to thermodynamically evaluate the effect of the implementation of the WHR cycle on the engine efficiency. For this purpose, the 16 cylinder MTU 4000 R43L heavy diesel engine was simulated and a comparison was made between numerical and experimental results. Finally, the SRC heat recovery cycle was designed and applied in the simulated model according to the desired limits and the temperature range of the engine operation. At low speed with the application of the WHR cycle, the output net power did not drop much, but at the maximum speed and power, a power loss of about 4% is observed. At 1130 rpm, the power did not increase much. At 1600 rpm, the power increase is reduced to about 2.3%. At 1800 rpm, due to the significant increase in exhaust gas temperature, the total power value increased by about 4%.
Energy
R. Aghagolzadeh Silakhor; O. Jahanian; B. Alizadeh Kharkeshi
Abstract
Using cogeneration systems is a great way to tackle fossil fuel consumption problems. This paper introduces a Combined Cooling Heating Power (CCHP) system to recover the waste heat of an RK215 heavy diesel engine as a prime mover. Therefore the CCHP system consists of Internal Combustion Engine (RK215), ...
Read More
Using cogeneration systems is a great way to tackle fossil fuel consumption problems. This paper introduces a Combined Cooling Heating Power (CCHP) system to recover the waste heat of an RK215 heavy diesel engine as a prime mover. Therefore the CCHP system consists of Internal Combustion Engine (RK215), a heat storage tank, and an absorption chiller. Also, the system has been studied in four modes: CCHP, CHP, CCP, and single generation. The waste heat ratio has changed due to a y factor, and the effect of this different parameter, such as the start of fuel injection and exhaust gas heat, on the system's efficiency by considering first and second laws of thermodynamic in different operating modes has been investigated. The system's highest energy and exergy efficiency in CCHP mode is equal to 50.46 and 30.8%, respectively. According to the result, as the CCHPs cooling load to the absorption chiller increases, the performance also rises. Also, the system’s carbon dioxide emissions reduction has been studied. The results showed that using different modes for waste heat recovery can reduce carbon dioxide by up to 30% approximately for different modes. Also, the fuel energy saving ratio (FESR) has been investigated, and the results showed that systems in CCHP, CHP, and CCP modes could have FESR approximately equal to 21%.
